tag:blogger.com,1999:blog-6100511197805579796.post8460922772295224417..comments2024-02-14T18:43:36.096+01:00Comments on Davide Gironi blog: esp8266/Arduino NTC libraryDavide Gironihttp://www.blogger.com/profile/16366076989473118278noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-6100511197805579796.post-23157871850042806712019-06-28T13:31:20.203+02:002019-06-28T13:31:20.203+02:00Hello, unluckly I have no time, I'm fully iunv...Hello, unluckly I have no time, I'm fully iunvolved in another project.Davide Gironihttps://www.blogger.com/profile/16366076989473118278noreply@blogger.comtag:blogger.com,1999:blog-6100511197805579796.post-36766584685903379932019-06-28T13:30:51.127+02:002019-06-28T13:30:51.127+02:00Hello, sorry for my delay. Unluckly not.Hello, sorry for my delay. Unluckly not.Davide Gironihttps://www.blogger.com/profile/16366076989473118278noreply@blogger.comtag:blogger.com,1999:blog-6100511197805579796.post-66973855753879597482018-10-30T01:41:35.030+01:002018-10-30T01:41:35.030+01:00Do you have time to help me with instruction where...Do you have time to help me with instruction where to put these helpers in espeasy firmware ?Anonymoushttps://www.blogger.com/profile/04469062100284109493noreply@blogger.comtag:blogger.com,1999:blog-6100511197805579796.post-20056662169344102552018-05-28T10:35:33.980+02:002018-05-28T10:35:33.980+02:00did you perchance implement an ADC write method us...did you perchance implement an ADC write method using PWM to simulate. I want to be able to report temp to non IOT things (thermostat/hvac) from GPIO on my ESP8266 to report temperatures from my home sensornet - rather than analog NTC. So an easy way to do this is to 'fake' the NTC temp as an output from the ESP.Joel Wiramu Paulinghttps://www.blogger.com/profile/16088111512060330648noreply@blogger.com