The NRI G-13.mft by Crane (https://www.cranepi.com/) is a versatile and high secure coin validator.
It can be programmed using the propretary WinEMP software and PC interface, or event it has some DIP Switch that can be used to program the device.
Unluckily it does not come with a UART interface. But it features a "machine tester" I/O interface we can use to track the inserted coins.
On page 50/51 of the Technical Documentation for NRI G-13.mft G-13.mft parallel Standard, Casino and AMU Models (from Version /4) 05.05 Hns/WP/ds Edition 1.2 BA.G13MFTPAR4-GB, we find the specification for the interface we could use.
For the G-13.mft standard/Casino model – vending machine 10pin interface, we notice that
PIN 1 is the GND while PIN 2 the VCC, we can use those pin to power the device on.
Moreover, if we scope on the PIN3,4,7,8,9,10 we may notice that as the datasheet said, the signal is active low when a coin is inserted on the specific line.
Because those PIN also inhibit a signal line we can even instruct the coin acceptor to disable a specific coin line. This will not be the case we are investigating here, I'm only interested in getting the coin signal.
For this reason I just connect the output of the Coin signal line, with a pullup resistor to our microcontroller.
That's easy, now it's just a pin reading matter, with a bit of debounching.
The schematics itself is simple. The main microcontroller is an ATmega8. The UART to USB adapter chip is the Silab CP2102, attached to a microUsb port.
For this project I've also design the PCB, which i prototype using a chinese PCBA service. We are able to build the final board after 3 prototype, that's because I'm not a pro in the PCB design, but I've to start somewhere. Then the company I work request 100 boards production from the chinese company. It was the first time that I try the PCBA service of a company, think this was a good experience, to start with a small and simple board like this one.
Code, Schematics and PCB
Notes
- read risk disclaimer
- excuse my bad english